-ESC in the Quattro: 4 in 1
-Output: continuous 30A, Burst 40A up to 10 seconds
-Input voltage: 2-6 cells lithium battery or 5-12 cells NiCd/NiMh battery
-BEC: 3.0A/ 5 V Switch mode BEC
-Refresh Rate of the Throttle Signal: 50Hz to 432Hz
-Weight: 112 grams
-Four speed controllers in one board
-Only 1 pair of battery wire needed
-Safety arming feature: Throttle range can be claibrated to be compatible with different transmitters
-Multiple program methods supported: transmitter stick, LED Program Card
-Compatible with Lipo battery and NiMH battery
-Internal timing can be changed to be suitable for different brushless motors
-Full protection: Low voltage cutoff / over heat protection / throttle signal loss protection
-Microprocessors use separate boltage regulator IC for better anti-jamming capability
-ESC stands for Electronic Speed Controller. It is an electronic motor controller which controls the speed, direction and possibly braking of a motor.
-BEC stands for Battery Eliminator Circuit. In radio control contexts, the BEC is extra circuitry on the ESC to provide power to the controls (such as steering, servos, receivers) to the controlled vehicle so that this control circuitry does not need to carry it’s own battery pack. That is, it piggy backs on the battery pack used to drive the motors of the vehicle or in other words, the motor and servos share the same battery pack.
-SBEC usually stands for Switching Battery Eliminator Circuit. SBEC’s are improved versions of BECs as the circuitry uses batter power more efficiently
– 1 x iPeaka 30A 4 in 1 Quattro ESC/ 2-6S
There are no reviews yet.